This origami koi fish is best made in a rectangle piece of paper with a ratio of 2:3.Bring all the folds together to form the body and hold it in place for a few seconds to allow the glue to dry.Next, apply glue to the inner section of the body.Start by opening up the folds and applying glue to the top section of the body.This is an optional step if you want to keep the folded paper, especially the body part, intact. And that completes all the folding steps to make the origami paper fish. This is how the back of the face should look like after folding. Fold a small triangle at the corner of the fish's face.Press the tail to bend at the end of the body.This is how the folded sides should look like.Next steps are to tidy the sides of the tail.Press the tail close firmly along all the folded lines.You will see a tiny triangle excess of the paper you folded in the earlier step. Open up the tail, and push the folded section up as shown.You will see the excess of the folded down paper at the bottom. Push the middle section of the tail down along the lines folded earlier.This is how it should look like after the folding steps above. Hold the fish in your hands and open up the tail.Turn the fish to the other side and fold the remaining one section of the tail down.Do the same for the next section of the tail.Fold the top most piece of paper in the tail section as shown.Once you have completed the body, place the fish down as shown.This steps completes the body of the origami koi fish. Bring the folded line on the left to the center.Bring the folded line to the center of the rectangle.Start by folding a diagonal line on the body section of the origami koi fish. Repeat the same process as the step above.Shaping the body of the paper fish (Part 2) Bring the folded line to the center of the rectangle and press it down.Fold a diagonal line on body section of the folded paper.Shaping the body of the paper fish (Part 1) Fold the folded rectangle into half, ending the fold at the base of the folded fins.Fold the extended sections of the paper towards the center line.Next, fold the pointed end of the triangle towards the other end of the rectangle.Fold both the top corners into a triangle. Fold and press the along the lines that were folded in the steps above. Bring both sides of the rectangle paper to the center, horizontally.Fold the folded paper into half again, horizontally.įolding the base of the origami koi fish body.Fold the paper into half, horizontally.This is how the larger section of the cut paper should look like.Use a paper knife to cut the paper at the fold.Measure and mark the 10cm point on both edges of the square paper.I used a 15cm by 15cm square sheet and cut it into 10cm by 15cm. If you are using a square piece of paper to make the origami koi fish, you need to cut it into a rectangle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |